Features :

• Support CompactFlash /PCMCIA ATA/True IDE Standards
• Host data transfer rate = 16.6Mbytes/sec (PIO4 data transfer)
• Flash interface: 8-bit access
• Host interface: 8/16-bit access
• Optimized flash memory management to maximize the data endurance and performance.
• Support ECC function to detect and correct data errors automatically.
• 100-pin TQFP/LQFP package
• Support the internal flash ROM to modify the firmware easily for special devices.
• Power supply requirement: Input Voltage: 3.3V/5.0V±10% TYPEⅠ,NAND Flash

The CFDISK.1E (Floppy) allows CompactFlash modules to be used in any system that includes a standard IDE 40 pin connector.
Once the platform starts with the adapter and the CF card plugged in, the compactflash module appears to the system to be a standard disk drive.
Unlike other flash storage systems such DiskOn-Chip modules this solution does not require drivers or additional software to run the unit.
The CF card can be the primary boot device containing the OS and application.

This adapter comes with a standard IDE cable that gets plugged into the IDE controller and can be jumpered as either master or slave.
Comes with a Floppy Disk power connector.
Jumper configuration for master or slave.

Product Links:
Schematics

Features :

• Dimension: 2x4 inches
• Support CompactFlashTM cards (Type I & II) or a IBM MicrodriveTM
• Due to limitations in the CompactFlash specification, this adapter does not support hot insertion of cards.
• Floppy disk power connector.
• Board is fully assembled (not a kit).
• Transparent to the operating system and does not require any drivers

The CFDISK.1E (IDE) allows CompactFlash modules to be used in any system that includes a standard IDE 40 pin connector.
Once the platform starts with the adapter and the CF card plugged in, the compactflash module appears to the system to be a standard disk drive.
Unlike other flash storage systems such DiskOn-Chip modules this solution does not require drivers or additional software to run the unit.
The CF card can be the primary boot device containing the OS and application.

Product Links:
Schematics	Datasheet

Features:

• Support CompactFlashTM cards (Type I & II) or a IBM MicrodriveTM
• Due to limitations in the CompactFlash specification, this adapter does not support hot insertion of cards.
• IDE power connector.
• Board is fully assembled (not a kit).
• Transparent to the operating system and does not require any drivers

Specifications:

• Jumper configuration for master (jumper on) or slave (jumper off). Supports IDE DMA.
• Solid state replacement for 3.5" hard disk drives, 40 pin IDE connector.
• Mounting hole locations same as the bottom holes of a hard disk drive.
• Comes with an IDE power connector onboard.
• Board size is 2" x 4".

Solid state replacement for hard disk drives, 40 pin IDE connector, floppy power connector.
This adapter is designed to plug directly onto the system board IDE connector.
Hardwired for IDE master.
Supports IDE DMA.

• Replacement for 3.5" hard disk drives, plugs directly onto a 40 pin IDE connector.
• Uses a floppy power connector.
• Configured as a master.
• Not recommended for high vibration environments.
• Installs "vertical" to the system board

Product Links: